When the fabric is woven to the preset length, the fabric is cut off and unloaded from the water jet loom.
This operation should start when the green light of the tower pole indicator lights up.
Attention：
·You must wait until the water jet loom stops before starting work.
• When removing the cloth roll, be careful not to get your hands and feet caught between the cloth roll and the ground.
(1) Confirm whether the water jet loom has stopped.
When the water jet loom is still running, the stop button should be pressed to stop the loom.
(2) Use the specified cutter to cut the fabric.
(3) Loosen the gripping handle 1 on the right, and pull it toward you. The cloth roll 2 can be loosened.
(4) Pull out the fabric roll 2 to the side before weaving.
(5) Fix the cut cloth roller with the prescribed method to prevent the fabric from loosening.
(6) Remove the cloth roll.
(7) Ask the person in charge to remove the unloaded cloth roller.
(8) Press the reset button 4 of the automatic counter, the counter display will return to <0 >.
(9) Fix the new fabric roll on the left fabric roll guide 3.
(10) Push up the right grip handle 1 and tighten. The new cloth roll can be fixed.
(11) Wait for the fabric to sag to the fabric winding position of the new cloth roll.
(12) Wet the cloth roll and the fabric with water, and wind the fabric on the cloth roll. At this time, the two ends of the fabric should be aligned and the fabric should be tight.
(13) After winding several times of fabric on the cloth roll, install the cloth roll pressure roller.
